The wire mesh material filter element can be cleaned and reused,save your costs.DKFILTER as a professional factory,we can provide you the cleaning procedures for wire mesh and notch wire filter elements here:
Make sure to clean dirty elements with a light crude (light oil, kerosene, etc.) using the following procedure.
For 40 mesh-40μm elements:
(1) Dip the filter element in light oil and rotate thoroughly.
(2)Clean off dirt by scrubbing the element with a brush parallel to the pleats.
(3)Clean off dirt with an air spray gun.
(4)Rinse well.
(5)Dry using an air spray gun.
For elements finer than 40μm
For wire mesh elements finer than 25μm, clean most of the dirt off the surface using the above cleaning procedure, then be sure to put the element through ultrasonic cleaning. Place the elements on the oscillator side vertically, one by one. The cleaning time is not necessarily decided by the ultrasonic cleaner capacity or how dirty the element is,so be sure to clean each element one after the other for at least 1 hour.
Note:
*Only elements for wire mesh and notch wire filters can be cleaned. Paper filter types must be changed.They are not to be cleaned.
Sanjiang Industrial Park, No. 5 Dingshan Road, Xiaoshan District, Hangzhou, Zhejiang Province, China.
Kai Gao
+86-18595606588
Sanjiang Industrial Park, No. 5 Dingshan Road, Xiaoshan District, Hangzhou, Zhejiang Province, China
© Copyright: 2012 Xiaoshan District, Hangzhou, Zhejiang Province, China Partner Environmental Protection Technology Co., Ltd.
